-
Specifications：
Item no. Flow rate max. head wattage UPC # 0069037 BH 1000AD 342 GPH 3.93 ft. 7.5 w 2941 3 BH 2000AD 600 GPH 4.92 ft. 20 w 2942 0 BH 4000AD 1105 GPH 8.53 ft. 46 w TBA BH 6000AD 1579 GPH 10.17 ft. 74 w TBA -
Parts：
- BH 1000AD
-
- Three tier head
- Two tier head
- Fountain head uplift
- Tube adapter
- Water bell head
- Fountain head adapter
- Uplift tubes
- Valve & water diverter
- Diverter cap
- Pump strainer
- Impeller cover
- Impeller
- Pump
- Additional pre-filter
- Additional pre-filter bracket
- Main pre-filter
- Clasp
- BH 2000AD：
- Water bell head
- Dual tier head
- Three tier head
- Uplift tube
- Uplift tube coupler
- Valve & water diverter
- Diverter cap
- Barbed pipe adapter
- Pump strainer
- Impeller cover
- Impeller
- Pump
- Additional pre-filter
- Additional pre-filter bracket
- Main pre-filter
- Clasp
-
Installation：
- Open both, front and back clasps.
See diagrams 1.1 and 1.2. - Now, open the main pre-filter.
- Connect the additional pre-filter to the main pre-filter. See diagram 2.
- Close the main pre-filter.
- Close and secure both clasps.
- See part list diagrams for model BH-1000AD and BH-2000AD fountain head installation.
- There are different options of the fountain head. Choose the appropiate setting depending on the application.
- Place the pump in desired location. If pump is placed in a pond, raise the pump off the bottom of the pond by a minimum of 6 inches.
- Start the ViaAqua® Pond Pump.
- Open both, front and back clasps.
-
Maintenance：
If the water flow decreases, it’s a clear sign that debris is in the impeller or the pre-filter is clogged. It is the hobbyist’s sole responsability to ensure the pump is maintained frequently. Failure to properly maintain the pump will cause premature damage to the ViaAqua® Pond Pump.
Recommended routine maintenance: every 30 days.- Disconnect the pump from the GFCI (Ground Fault Circuit Interrupter) power supply prior to removing the pump from the water.
- Open both, front and back clasps.
- Remove the pump from the main pre-filter.
- Clean the main and additional pre-filter.
- Remove the impeller well cover.
- Once the impeller well cover is removed, slide both the impeller and shaft out of the main body of the pump, and clean it well.
- Verify the impeller is free of all dirt and debris.
Note: Do not use any soap or detergent during cleaning. - Once the impeller and shaft are cleaned, use a small brush to clean inside the motor housing.
- Place the impeller back into the pump.
- Reassemble above parts and your ViaAqua® Pond Pump is ready to use. Note: All washer and bushing must be reassembled properly. Failure to do so will cause permanent damage to the pump.
- Insert the pump back to the main pre-filter. Attach additional pre-filter and start the ViaAqua® Pond Pump.
Vestibulum curae torquent diam diam commodo parturient penatibus nunc dui adipiscing convallis bulum parturient suspendisse parturient a.Parturient in parturient scelerisque nibh lectus quam a natoque adipiscing a vestibulum hendrerit et pharetra fames nunc natoque dui.
